Harwin Z80-294 Manual de usuario descargar pdf

IS-29 Issue: 4 Date: 16.12.2010 C/Note: 11057 Page 1 of 3

HAND CRIMP TOOL Z80-294 (M22520/1-01)

This Hand Crimp Tool has been designed for use with the following Datamate Mix-Tek Power Crimp

Sockets [when used with Positioner Z80-295 (TP1663)]:

M80-338 .......................... Male power crimp contact for 18 AWG wire

(Used in Mix-Tek male crimp connectors).

M80-328 .......................... Female power crimp contact for 18 AWG wire

(Used in Mix-Tek female crimp connectors).

M80-339 .......................... Male power crimp contact for 20 AWG wire

(Used in Mix-Tek male crimp connectors).

M80-329 .......................... Female power crimp contact for 20 AWG wire

(Used in Mix-Tek female crimp connectors).

GENERAL INFORMATION

The Hand crimp tool M22520/1-01 consists of a basic hand tool, which should be used with a positioner.

The contact is correctly crimped when the tool is free to open at the fully closed position, i.e., when the

ratchet releases. The tool cannot be opened without completing the cycle.

Harwin North America Harwin Europe Harwin Asia

T: +1 603 893 5376 F: +1 603 893 5396 T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 T: +65 6 779 4909 F: +65 6 779 3868

E: [email protected] W: www.harwin.com E: mis@harwin.co.uk W: www.harwin.com E: [email protected] W: www.harwin.com.sg

Spring Clip

Tool in Closed Position

Retainer Ring

Selector Knob

Selector Index

1 2 3

IS-29 Issue: 4 Date: 16.12.2010 C/Note: 11057 Page 1 of 3 HAND CRIMP TOOL Z80-294 (M22520/1-01) This Hand Crimp Tool has been designed f

IS-29 Issue: 4 Date: 16.12.2010 C/Note: 11057 Page 2 of 3 TOOL PREPARATION 1. Check that the tool is in the open position. 2. Place pos

IS-29 Issue: 4 Date: 16.12.2010 C/Note: 11057 Page 3 of 3 3. Position the crimp socket fully into the positioner, with the crimp barrel

Sin comentarios

Harwin Z80-294 Manual de usuario