Harwin Z80-299 Manual de usuario descargar pdf (Pagina 3)

IS-30 Issue: 2 Date: 22.09.10 C/Note: 10949 Page 3 of 4

DE-LATCHING TOOL Z80-299

Separating the Connectors

The pictures below show the 60mm long multi-positional bar being used to separate both vertical

and horizontal DIL connectors. Shown below is a 20 way connector, with the tool in the “Ready”

position, prior to separating the connectors.

 Both jaws must be centrally positioned, resting the tool on the two latches.

 The multi-positional bar must be kept parallel to the moulding at all times to prevent breaking

the latches.

 Square Cut outs in the jaws must be aligned to clear the “Clip” feature of the latches /

mouldings when pushed onto connector.

Once correctly positioned the tool can then be pushed on until the hook features of the jaws grip

the female moulding.

 The picture on the right shows how the tool should look once engaged

ready to separate mated connectors.

Harwin North America Harwin Europe Harwin Asia

T: +1 603 893 5376 F: +1 603 893 5396 T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 T: +65 6 779 4909 F: +65 6 779 3868

E: misboston@harwin.com W: www.harwin.com E: [email protected] W: www.harwin.com E: [email protected] W: www.harwin.com.sg

“Clip” feature Close up

Square cut outs “Clip” feature

“Ready” position

1 2 3 4

Sin comentarios

Harwin Z80-299 Manual de usuario Pagina 3